Freshwater Lamp

Freshwater Lamp

EXTRA HIGH OUTPUT
Rich Green Colours

  • Bright white light with a soft green tint
  • Excellent colour rendition
  • Enhances the rich greens in plants
  • Supports aquatic plant-life

For best results use with an Arcadia Luminaire or Electronic Controller and replace after two years of normal use.

Description

Code Watt Length Diameter Lumens Energy kWh/1000h
FFF08 8W 12″/300mm T5-16mm A 9
FFF14 14W 15″/360mm T8-26mm 550lm A+ 16
FFF15 15W 18″/450mm T8-26mm 700lm B 19
FFF18 18W 24″/600mm T8-26mm 1000lm A 22
FFF25 25W 30″/750mm T8-26mm 1800lm A 31
FFF30 30W 36″/900mm T8-26mm 2000lm A 36
FFF36 36W 48″/1200mm T8-26mm 2900lm A 43
FFF38 38W 42″/1050mm T8-26mm 2700lm A 45
FFF58 58W 60″/1500mm T8-26mm 4200lm A 68

Code Watt Length Diameter Lumens Energy kWh/1000h
FFF24T5 24W 22″/550mm T5-16mm 1220lm A 26
FFF39T5 39W 34″/850mm T5-16mm 2350lm A+ 44
FFF54T5 54W 46″/1150mm T5-16mm 3330lm A+ 60

Product Safety

Lamps can be fragile pieces of equipment. Please follow the following steps to ensure the safe fitting and use of fluorescent lamps.

At either end of a fluorescent lamp you will see two brass coloured connection pins. These are the electrodes that take energy from the controller to start and run the lamp. These are quite fragile by nature. It is imperative that both pins are safely located into the pin sockets inside the lamp holder before the lamp is pressed into place. Failure to line the pins up correctly will cause the pins to bend and snap and break through the lamp cap rendering the lamp unusable.

The Ultra-seal lamp ring must be unscrewed from the lamp holder and placed over the lamp prior to fitting and only re-seated onto the lamp holder when you are sure that the lamp pins are seated correctly. High Output T5 lamp leads must be fully unwound also or you may notice lamp flickering or beaks in illumination. You can also use a very small amount of a substance like Vaseline to lubricate the lamp ring and so stop it fusing to the lamp after long periods of heat. After cooling lamps can be wiped clean with a damp cloth once every two weeks or so to remove any dust build up from the lamp, this in turn will help to maintain the lamps full output. The all important reflector should also be wiped clean at the same time.

You may also like…