Marine Hybrid 60/40

/, Lighting, Marine, T5/Marine Hybrid 60/40

Marine Hybrid 60/40

Actinic white lamp that enhances blue and violet marine colours.

  • 60% Marine White 14,000K / 40% Marine Blue 420nm
  • Actinic white lamp that enhances blue and violet marine colours
  • High photosynthetic light content

The Marine Hybrid is a new T5 lamp formulation based on a 60/40 phosphor mix of our Marine White 14K and Marine Blue 420nm lamps. The resultant spectrum of the lamp combines high brightness, with large amounts of energy in the photosynthetic wavelengths required for coral growth.

With a strong actinic peak to fluoresce corals, the Marine Hybrid lamp emphasises blue and violet colours in the aquarium, without flattening reds and greens, giving a natural reef appearance.

For smaller aquariums the Hybrid lamp works well on its own or combined with the Marine white lamp, while in larger T5 lamp arrays, a mix of Arcadia Marine Blue, Marine Hybrid and Marine White lamps will produce excellent results.

Categories: , , ,

Description

Code Watt Length Diameter Lumens Energy kWh/1000h
FFMH24T5 24W 22″/550mm T5-16mm 740lm A 26
FFMH39T5 39W 34″/850mm T5-16mm 1400lm A+ 44
FFMH54T5 54W 46″/1150mm T5-16mm 1800lm A+ 60
FFMH80T5 80W 58″/1450mm T5-16mm 2550lm A+ 85
FFMHJ24S 24W 18″/438mm T5-16mm 640lm A 26
FFMHJ28 28W 24″/590mm T5-16mm 800lm A 30
FFMHJ35 35W 30″/742mm T5-16mm 1900lm A 40
FFMHJ45 45W 36″/895mm T5-16mm 1500lm A 50
FFMHJ54S 54W 42″/1047mm T5-16mm 1750lm A 60
FFMHJ54L 54W 48″/1200mm T5-16mm 1950lm A 60

Compact

Code Watt Length Diameter Lumens Energy kWh/1000h
FFMHC11 11W 9″/230mm G23 A 13

Product Safety

Lamps can be fragile pieces of equipment. Please follow the following steps to ensure the safe fitting and use of fluorescent lamps.

At either end of a fluorescent lamp you will see two brass coloured connection pins. These are the electrodes that take energy from the controller to start and run the lamp. These are quite fragile by nature. It is imperative that both pins are safely located into the pin sockets inside the lamp holder before the lamp is pressed into place. Failure to line the pins up correctly will cause the pins to bend and snap and break through the lamp cap rendering the lamp unusable.

The Ultra-seal lamp ring must be unscrewed from the lamp holder and placed over the lamp prior to fitting and only re-seated onto the lamp holder when you are sure that the lamp pins are seated correctly. High Output T5 lamp leads must be fully unwound also or you may notice lamp flickering or beaks in illumination. You can also use a very small amount of a substance like Vaseline to lubricate the lamp ring and so stop it fusing to the lamp after long periods of heat. After cooling lamps can be wiped clean with a damp cloth once every two weeks or so to remove any dust build up from the lamp, this in turn will help to maintain the lamps full output. The all important reflector should also be wiped clean at the same time.

Reviews

There are no reviews yet.

Be the first to review “Marine Hybrid 60/40”

Your email address will not be published. Required fields are marked *

You may also like…