Marine White 14,000K

/, Lighting, Marine, T5, T8/Marine White 14,000K

Marine White 14,000K

The colour temperature and spectrum of the Marine White 14,000K lamp, coupled with its high lumen output (particularly for the T5 lamps) replicates the intensity of the sun around shallow coral reefs.

  • Powerful penetrating white light
  • Accentuates natural fish colours
  • Colour replicates reef environment
  • Promotes marine photosynthesis
  • Ideal for lighting African Lake tanks

The Arcadia Marine White lamp has a colour temperature of 14,000K (Kelvin) and an exceptional lumen output combined with very good colour rendition. The tri-phosphor formulation provides consistent long life and stability of output at these high levels of performance.

These factors make it the ideal choice for the serious marine aquarist, with excellent levels of light throughout the aquarium and extraordinary clarity for viewing the constantly changing marine environment.

A high proportion of light energy is concentrated in the area between 400 and 480nm, which also assists in the promotion of zooxanthellae production to encourage coral and invertebrate growth.

The other peaks across the spectrum allow the true, vibrant and natural colours of the fish, corals and invertebrates to be enhanced and to really stand out.

Categories: , , , ,

Description

Code Watt Length Diameter Lumens Energy kWh/1000h
FFMW15 15W 18″/450mm T8-26mm 500lm B 19
FFMW18 18W 24″/600mm T8-26mm 850lm A 22
FFMW25 25W 30″/750mm T8-26mm 1600lm A 31
FFMW30 30W 36″/900mm T8-26mm 1600lm A 36
FFMW36 36W 48″/1200mm T8-26mm 2100lm A 43
FFMW38 38W 42″/1050mm T8-26mm 2000lm A 45
FFMW58 58W 60″/1500mm T8-26mm 3300lm A 68

Code Watt Length Diameter Lumens Energy kWh/1000h
FFMW14K24T5 24W 22″/550mm T5-16mm 1250lm A+ 26
FFMW14K39T5 39W 34″/850mm T5-16mm 2300lm A 44
FFMW14K54T5 54W 46″/1150mm T5-16mm 3100lm A 60
FFMW14K80T5 80W 58″/1450mm T5-16mm 4310lm A 85

Product Safety

Lamps can be fragile pieces of equipment. Please follow the following steps to ensure the safe fitting and use of fluorescent lamps.

At either end of a fluorescent lamp you will see two brass coloured connection pins. These are the electrodes that take energy from the controller to start and run the lamp. These are quite fragile by nature. It is imperative that both pins are safely located into the pin sockets inside the lamp holder before the lamp is pressed into place. Failure to line the pins up correctly will cause the pins to bend and snap and break through the lamp cap rendering the lamp unusable.

The Ultra-seal lamp ring must be unscrewed from the lamp holder and placed over the lamp prior to fitting and only re-seated onto the lamp holder when you are sure that the lamp pins are seated correctly. High Output T5 lamp leads must be fully unwound also or you may notice lamp flickering or beaks in illumination. You can also use a very small amount of a substance like Vaseline to lubricate the lamp ring and so stop it fusing to the lamp after long periods of heat. After cooling lamps can be wiped clean with a damp cloth once every two weeks or so to remove any dust build up from the lamp, this in turn will help to maintain the lamps full output. The all important reflector should also be wiped clean at the same time.

You may also like…